Technical Information - Passenger Cars
10/2011
Glasurit® Coagulating powder
700-7
 
G / X

Application:

 

When using water-borne products such as:

  • Glasurit® 90 Line Basecoat, Metallics/Solids
  • Glasurit® 176-72 1K Primer Filler
  • Glasurit® 1109- Stone Chip and Underbody Protection
  • Glasurit® 1109- Texture Finish

the water used to clean working tools should be collected in suitable containers.

These containers must not get in touch with solvents.

 

Use of 700-7 Coagulating Powder: Add 2 or 3 scoops of 700-7 Coagulating Powder (approx. 75 g) per about 10 litres waste water (scatter the powder to distribute the particles evenly and to increase efficiency) and stir briefly.

 

After a short interval, the solids will start to coagulate and can then be separated from the liquid by filtering, for example through filter mats or appropriate sieves (with a mesh size of about 80-100 microns).

 

When the contaminant concentration in the waste water is very high (i.e., when the water has not become clear after about 15 minutes), add more 700-7 Coagulating Powder. There is no risk of overdosing with 700-7.

 

The coagulated substance must be disposed of in the same way as solvent-borne paint waste. The clear, aqueous phase may be discharged into the public sewage system subject to local waste-water regulations. When you are not sure, consult the competent local authorities.

Properties:

 
  • Glasurit® 700-7 Coagulating Powder is used to precipitate solids from the water used to clean working tools with which water-based products were processed.
  • Once the coagulated substance has been separated, the clear, aqueous phase can be used again for pre-cleaning sprayguns, which are finally rinsed with fresh tap water.
to top

Paint system

RATIO Aqua